50mm Branson Type Ultrasonic Transducer 20khz for Branson 2000 Series
Ultrasonic Transducer introduction:
Ultrasonic transducer uses the piezoelectric effect to realize transduction between electric and sound energy. It comprises a radiation head, electrode, cap, prestressed bolt, piezoelectric chip and an insulating tube. The Ultrasonic transducer is widely used in ultrasonic cleaning machine and high-power industry cleaning devices
PS:we can also customize depend on your requirements.
Q: What will happen if the frequency is not matched well?
A:After the ultrasonic transducer is connected to the horn and the die head, the resonance frequency of the system will become very sharp, that is, the bandwidth is very narrow, the mechanical quality factor is very large, and the frequency deviation will cause a large increase in impedance. Performance on the drive power supply is the power (amplitude meter power) is large or overload protection. If this happens to be an idler at this time, it is likely that the wafer will be misaligned, and the wafer may crack or the center screw may break.
Q:How to change the old transducer by a new one?
A:Remove the positive and negative external wires of the old transducer, remove the glue with external force and degumming solution, loosen the screws with a wrench, handle the contact surface, and install the new transducer in the above order.
Q:How to measure the parameters of the transducer?
A:You need an ultrasonic impedance analyzer to measure the parameters, also we can provide this device,just contact us.