Ultrasonic Plastig Welding Machine -How was the bottom mold replaced?
Today we will continue to explain some knowledge about the accessories of ultrasonic plastic welding machine-How was the bottom mold replaced?
Let's watch the video and listen to our engineer Mr. Chen's explanation.
We used the first mold 100 * 10.
Now change to a 10 * 25 mold
This tool is also sufficient for replacingthe bottom film Press this underfilm.
Come on. Loosen it. The two pressing blocks of this mold are on both sides
So it need to be installed on both sides.
Not in the same direction as before.
Don't tighten it yet.
In order to ensure the alignment of the upper and lower molds, the lower molds are adjusted accurately according to the position of the upper molds by pressing the upper molds.
Switch to modulating mode here, and move it up about 10 centimeters, then start it up.
Push the probe down, give downward pressure All right, when we're done, Adjust the pressure opening position so that it can hold the base membrane underneath this.
Why don't you lift this up?
It's already fixed.
Switch to working mode after setting Are you clearly?
if No, pls contact us for more detail information.
Contactor: Ms. Hogo Lv Business
Phone:0086-15158107730
Whatsapp:0086-15158107730
Skype: clover_lhg
Email:admin@altrasonic.com