The rear partition of the automobile is generally applied to two kinds of processes: one is the hot-melt riveting point welding of the automobile rear partition plastic column, and the other is the ultrasonic puncture welding of the plastic rear part of the automobile rear partition. The position of the different rear partitions of the automobile needs to be welded, after the automobile The separator welding opportunity is applied to the ultrasonic or hot riveting process.
Automobile rear partition hot-melt riveting point welding machine
Riveting the plastic column and holding the rear partition of the car
automobile rear baffle hot-melt riveting spot welding picture
The multi-head hot rivet welding process can be used to form the rear pillar plastic column of the automobile.
Such a car interior parts hot-melt riveting point, smooth surface
Automobile rear partition plastic pendant ultrasonic welding machine
Generally, the plastic buckle of the automobile rear bulkhead is ultrasonically welded and welded, and the hot-melt welding can also be used for the rear partition of the automobile with good weldability.
The rear partition of the car is distributed at various positions, suitable for ultrasonic welding, and the ultrasonic angle can be switched.
Automotive rear bulkhead plastic pendant ultrasonic welding machine introduction:
Simultaneous welding with multi-head ultrasonic system (domestic or imported system)
Safety devices such as safety gratings, tank chains, start and emergency stop buttons
PLC man-machine interface control, high precision, stable performance
High-strength steel is used as the frame and linear guide, and the four-column design is more stable.
Each position has a blowing device, the cylinder is driven, and semi-automatic production is carried out.
To sum up:
The car rear partitions of each auto supplier are different, and the most suitable process is adopted according to the specific product.