Ultrasonic Vibration-Assisted Machining Equipment
The transducer vibrates the sonotrode at low amplitudes and high frequencies. The sonotrode is usually made of low carbon steel. A constant stream of abrasive slurry flows between the sonotrode and work piece. This flow of slurry allows debris to flow away from the cutting area. The slurry usually consists of abrasive boron carbide, aluminum oxide or silicon carbide particles in a suspension of water (20 to 60% by volume). The sonotrode removes material from the work piece by abrasion where it contacts it, so the result of machining is to cut a perfect negative of the sonotrode's profile into the work piece. Ultrasonic vibration machining allows extremely complex and non-uniform shapes to be cut into the workpiece with extremely high precision.
l CVD Silicon Carbide
l Ceramic Matrix Composites
l Technical Ceramics
According to customer requirements, it can be customized.
Q:I have some materials to WELD/CUTTING/SEWING, but i don’t know the effects it works?
A:Just let us know the materials and the thickness ,our engineer will check it and design the special method to made it .We accept samples from customers, do free test for customer.
Q:When can we get the reply ?
A:Any inquires will be replied with 24hours.Our sales team will try our best to support you,and welcome to call us if you have any question or immediate support .
Q:Is ultrasonic harmful to heath?
A:No, ultrasonic frequencies between 20 and 35 kHz are not harmful to humans. Sometimes unpleasant whistling side noises will occur. Therefore machines in the lower frequency range often have sound insulation.
|注：可使用其他编辑器编辑内容后复制到填写框中 其他HTML编辑器 FCKHTML编辑器|